Guest wireless accounts may be granted to visitors who are sponsored by a Concordia department and unable to connect via the eduroam wireless network.Most Windows 10 devices will not require configuration and will connect automatically if you select the Concordia University network and provide a valid netname and password when prompted. A new window will open, allowing you to choose a connection option. The Wireless Network Properties window will appear. The network authentication method should be Microsoft Protected EAP (PEAP). Unselect 'Verify the server's identity by validating the certificate', then click 'Configure'. A pop-up window named 'EAP MSCHAPv2 Properties' will appear. In the Advanced settings window, select 'Specify authentication mode' and select 'User or computer authentication'. Requirements: - Fully updated operating system - Make certain your wireless card is enabled and that the antenna isn't turned off if it's built in - You need to be logged into Windows using an account with administrative privileges Steps to follow: - Click : Some Windows users (Windows 7 and 8) receive a popup window the first time they access Concordia's wireless network.To set up an Android Device’s Wi-Fi, select "Menu" on the home page, then select "Settings". Once the "Wi-Fi icon is green, tap "Wi-Fi Settings". For the "Identity" and "Anonymous Identity" fields and the corresponding password, use your NTU Vo IP user name and password (not your C&INC information).In the "CA Certificate" and "User Certificate" fields, select "Not Specified" for both, then select "Connect". Click below for information on how to connect your devices to the Stockton network.You can initially connect your laptop or mobile device(s) to the internet from campus using Stockton-Wireless.Select either "jyu-student" or "jyu-staff" as the wireless network and click "Connect" Type in your JYU username password and click "OK". when using eduroam you will need to type your username as [email protected](e.g.

Under "General", check "Internet Protocol (TCP/IP)", then select "Properties" In the "Internet Protocol (TCP/IP) window, select "General", then select "Obtain and IP Address Automatically" and "Obtain DNS Server Address Automatically", then click "OK" In the "Network Authentication" section, select "WPA", for "Data Encryption", select "TKIP".In case you get an error message or the wireless network does not connect, please check that you have written your JYU username and password correctly, and check that you have set the correct settings as instructed above starting from section 6. jyu-student and jyu-staff networks work on Windows 7 simply by connecting to the network and entering your JYU username password, without setting any special settings. Within JYU campus area please primarily use either jyu-student or jyu-staff networks!If you are at the campus area, simply connect to jyu-student or jyu-staff networks and enter your JYU username password. The only difference is that when connecting to eduroam, you will need to type your username as [email protected](e.g. jyu-student and jyu-staff networks need specific settings to be set before they work on Windows XP. Click "OK" once again The certificate has now been installed and you can proceed setting the wireless network settings manually. Double click the wireless netwok icon on the right side on the taskbar on the desktop. Select "Change the order of preferred networks" 11.For more information on how to connect to Stockton’s wireless network, refer to the links below.After 12 years, support for Windows XP ended April 8, 2014.